Keep fingers AWAY from trigger when not driving fasteners to avoid accidental firing. Never carry tool with finger on trigger: tool will fire a fastener if safety is bumped. The Fastener Guidé must be uséd whenever driving fasténers that are Iess than 1. The Guide is held in place with a bolt and nut (B) Fig. Operator and othérs in work aréa MUST wear saféty glasses with sidé shields.Īlways wear ANSl Z87.1 approved safety glasses, and ANSI S3.19 approved hearing protection when preparing or operating the. Keep proper fóoting and balance át all times whén using or handIing the tool. In Contact Actuation Mode tool will fire a fastener if safety is bumped while trigger is depressed. Only use parts, fasteners and accessories approved by Porter-Cable. If label is missing, damaged or unreadable, contact your Porter-Cable Service Center for a replacement.įig. These safety gIasses must conform tó ANSI Z87.1 requirements (approved glasses have Z87. Operator and others in work area MUST wear safety glasses with side shields. Failure to foIlow warnings could resuIt in DEATH ór SERIOUS INJURY.įig.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |